Heating & Furnace Repair in Memphis, TN — Emergency Service Available
When your furnace or heating system fails during a Memphis winter cold snap, prompt repair is critical. Mid-South HVAC Direct connects Memphis homeowners with local HVAC technicians providing fast furnace repair, heat pump service, and emergency heating restoration across Shelby County and surrounding areas.
Heating Problems We Repair in Memphis
Furnace Not Heating
Failed ignitor, dirty flame sensor, or gas valve issues prevent your furnace from producing heat. Our local technicians quickly diagnose and restore heat to your Memphis home.
Heat Pump Not Working
Heat pumps are popular in Memphis due to mild winters. Reversing valve failure, refrigerant issues, or defrost sensor problems can leave you without heat — fast repair available across Shelby County.
Furnace Short Cycling
A furnace that turns on and off rapidly often indicates an overheating issue, dirty flame sensor, or blocked flue. Left unaddressed, this strains the heat exchanger and blower motor.
No Heat from Vents
Blower motor failure, ductwork leaks, or a broken zone control board can prevent warm air from reaching your rooms even when the furnace is running normally.
Memphis Furnace Repair vs. Replacement
Memphis winters are milder than most of the country, but that doesn't mean furnace failures are less disruptive. When overnight temperatures drop into the 20s — as they do multiple times each winter across Shelby County — a non-functioning furnace is an emergency. The repair-vs-replace decision in Memphis depends on system age, repair cost, and efficiency:
- Under 10 years old: Repair is almost always cost-effective for components like igniters, flame sensors, pressure switches, and capacitors.
- 10–15 years old: Evaluate carefully. If repairs exceed 30–40% of replacement cost, or if the system has had multiple failures, replacement may offer better long-term value.
- Over 15 years old: Consider replacement, especially for older high-efficiency systems where parts are becoming scarce or for systems with cracked heat exchangers (a safety issue requiring immediate attention).
Memphis HVAC technicians can provide an honest assessment after diagnosis, helping you make the most cost-effective decision for your specific system and budget.
Heat Pump Service in Cordova, Germantown & Eastern Shelby County
Many newer Cordova, Germantown, and Collierville homes use high-efficiency heat pump systems rather than traditional gas furnaces. These systems are efficient in Memphis's mild winters but require specialist knowledge when problems occur. Common heat pump issues in the Cordova and eastern Shelby County area include:
- Reversing valve failure: Causes the heat pump to blow cool air in heating mode — the most disorienting heat pump failure for homeowners.
- Defrost board malfunction: Prevents the outdoor coil from properly clearing frost during cold nights, reducing heating efficiency significantly.
- Refrigerant issues: Low refrigerant in a heat pump causes both cooling and heating capacity loss — requires leak detection and repair before recharging.
- Auxiliary heat failure: Electric heat strips provide backup heat on very cold nights. A failed sequencer or heat strip leaves the system without cold-weather backup capacity.
Call (833) 561-1097 for heat pump repair service in Cordova, Germantown, Collierville, and all of Shelby County.
More Memphis HVAC Services
Heating Repair FAQs — Memphis, TN
How much does furnace repair cost in Memphis TN?
Furnace repair in Memphis TN typically ranges from $150–$500 for common issues such as ignitor replacement, flame sensor cleaning, or control board repair. More extensive repairs like heat exchanger replacement range from $500–$1,500.
Why won't my furnace turn on in Memphis?
Common reasons a furnace won't start in Memphis TN include a faulty ignitor, dirty flame sensor, tripped pressure switch, malfunctioning control board, or thermostat issues. Gas supply problems and clogged air filters are also frequent culprits.
Do heat pumps work well in Memphis winters?
Yes. Memphis's mild winters make heat pumps an excellent choice for Shelby County homes. Most heat pumps operate efficiently down to around 30–35°F, and Memphis rarely sees temperatures below that threshold. Many Memphis homes use dual-fuel systems — a heat pump for mild winter days combined with a gas furnace backup for the occasional cold night.
What causes heat pump problems in Cordova and Shelby County?
Heat pump problems in Cordova and surrounding eastern Shelby County are often related to defrost board failures, reversing valve issues (which cause the system to blow cool air in heating mode), or refrigerant leaks. Cordova-area homes with systems installed in the 1990s–2000s may have aging equipment approaching their service life.